To Next PageTo Next Page
Need help?Do you have a question about the Philips 47PFL6008S/12 and is the answer not in the manual?
General| Screen Size | 47 inches |
|---|---|
| Resolution | 1920 x 1080 pixels |
| Display Technology | LED |
| 3D | Yes |
| Smart TV | Yes |
| HDMI Ports | 4 |
| USB Ports | 3 |
| Wi-Fi | Yes |
| Ethernet | Yes |
| Digital signal format system | DVB-T/T2/C/S/S2 |
| Internet TV | Yes |
| Component video (YPbPr/YCbCr) in | 1 |
| Common interface (CI) | Yes |
| Common interface Plus (CI+) | Yes |
| RMS rated power | 20 W |
| Weight | 14.2 kg |
| Operating System | Philips Smart TV |
Details product information, getting started, manuals, FAQs, software and drivers.
Details on how to connect the TV to various devices.
Essential safety guidelines to follow during repair procedures.
Explains different service modes like SDM, SAM, and CSM.
Procedure to activate and use the Service Default Mode for pre-defined settings.
Information on activating and using the Service Alignment Mode.
Procedure to activate and utilize Customer Service Mode for customer support.
Describes the TV startup process and state transitions.
Information on error codes, their display, and logging.
Methods for clearing the error buffer from SAM or other means.
Discusses error detection mechanisms and logging.
Procedure for diagnosing issues using the front LED blinking patterns.
Details on software protections implemented in the TV.
Explanation of various software-related protection mechanisms.
General tips and guidance for troubleshooting and repairing faults.
Information on using Customer Service Mode for field feedback.
Details on the TV's power supply architecture and voltage distribution.
Step-by-step instructions for replacing the SSB.
Procedures for upgrading the TV's main and standby software.
Method for upgrading standby software using a USB stick.
Conditions and requirements for performing electrical adjustments.
Step-by-step guide for setting options and performing alignments.
Procedures for software-based alignments.
Steps for aligning the white point of LCD screens using picture settings.
Information on configuring set options via SAM or option codes.
Procedure to reset the NVM on a repaired SSB.
A summary table of available SAM modes and their functions.
Introduces the QFU1.2E LA chassis and its relation to FUSION platform.
Provides an overview of the FUSION 2013 architecture.
Details about the power supply unit and its replacement.
Information on ordering new power supply boards and replacing fuses.
Refers to Figure 7-2 for the power architecture.
Diagram illustrating the power supply lines and voltage distribution.
Circuit diagram for the SSB (Single-Board Solution).
