of 1MHz. Using the 1MHz steps will take more time to
search for and install channels.
Network frequency mode
If you intend to use the fast Quick method in Frequency
scan to search for channels, select Automatic. The TV will
use 1 of the predefined network frequencies (or HC -
homing channel) as used by most cable providers in your
country.
If you received a specific network frequency value to
search for channels, select Manual.
Network frequency
With the Network frequency mode set to Manual, you
can enter the network frequency value received from
your cable provider here. To enter the value, use the
number keys.
Network ID
Enter the network ID supplied by your cable provider.
Symbol rate mode
If your cable provider did not give you a specific symbol
rate value to install the TV channels, leave the Symbol
rate mode setting on Automatic.
If you received a specific symbol rate value,
select Manual.
Symbol rate
With the Symbol rate mode set to Manual, you can
enter the symbol rate value by using the number keys.
Free / Scrambled
If you have a subscription and a CAM - Conditional
Access Module for pay TV services, select Free +
scrambled. If you did not subscribe to pay TV channels or
services, you can select Free channels only.
Automatically Search for Channels
(Home) > Settings > Install
Channels > Antenna/Cable installation > Automatic
channel update
If you receive digital channels, you can set the TV to
automatically update the list with new channels.
Alternatively, you can start a channel update yourself.
Automatic channel update
Once a day, at 6 AM, the TV updates the channels and
stores new channels. New channels are stored in the All
channels list but also in the New channels list. Empty
channels are removed.
If new channels are found or if channels are updated or
removed, a message is shown at TV start up. The TV must
be in standby to automatically update channels.
Channel Update Message
(Home) > Settings > Install
Channels > Antenna/Cable installation > Channel
update message
When new channels are found or if channels are
updated or removed, a message is shown at TV start up.
To avoid this message to appear after every channel
update, you can switch it off.
Digital: Reception Test
(Home) > Settings > Install
Channels > Antenna/Cable installation > Digital:
reception test
The digital frequency is shown for this channel. If the
reception is poor, you can reposition your antenna. To
check the signal quality of this frequency again,
select Search and press OK.
To enter a specific digital frequency yourself, use the
remote control digit keys. Alternatively, select the
frequency, position the arrows on a number
with and and change the number with and . To
check the frequency, select Search and press OK.
Analogue: Manual Installation
(Home) > Settings > Install
Channels > Antenna/Cable installation > Analogue:
manual installation
Analogue TV channels can be manually installed, channel
by channel.
• System
To set up the TV system, select System.
Select your country or the part of the world where you
are now and press OK.
• Search Channel
To find a channel, select Search Channel and press OK.
You can enter a frequency yourself to find a channel or
let the TV search for a channel. Press OK,
select Search and press OK to search for a channel
automatically. The found channel is shown on screen and
if the reception is poor, press Search again. If you want
to store the channel, select Done and press OK.
• Fine tune
To fine tune a channel, select Fine tune and press OK.
You can fine tune the channel with or .
If you want to store the channel found, select Done and
press OK.
• Store
21
To Next Page
Loading...
Need help?
General
Weight and Dimensions
