Dismantling
Dee
Head
For dismantling / assembling the DCC head follow picture 1 to
4.
The DCC head
is
very sensitiv against ESD. Therefore it's absoluteley necessary to wear a
wrist wrap.
2.1
Lift the DCC head
2.2 Press to remove the DCC head
1.1
Remove bearing clamp (pos. 140)
1.2 Insert mounting support (4822 403 70846)
1.3 Turn DCC head to bring tooth segment lever
(pos.65) in correct position. See fig.
2
f fig. 2
fig.3
3.1
Check if the tooth segment lever (pos. 65)
is
in the
correct position.
3.2 Insert DCC head so that ribs on the head align to the
ribs of the tooth segment lever.
4.1
Insert bearing clamp
4.2 Remove mounting support
CS 45 942
58
To Next Page
Loading...
