Philips 9000 series - Page 14

Mechanical Instructions
EN 14 Q551.1E LA4.
2010-Jun-25
back to
div. table
4.4.9 LCD Panel
Refer to Figure 4-8
to Figure 4-10 for details.
Figure 4-8 LCD board [1/2]
Figure 4-9 LCD board [2/2]
1. Remove all boards as described earlier.
2. Remove the stand support as described earlier.
3. Remove the tweeters as described earlier.
4. Remove the subwoofer as described earlier.
5. Remove all cables.
6. Remove the Vesa stand.
7. Remove the tweeter subframes.
8. Release the clips [1] [2] that secure the LCD panel.
Figure 4-10 LCD board -3-
When remounting, ensure that the clips are not bent open!
4.5 Assy/Panel Removal Rubens Styling
The instructions apply to the 32PFL9705x/xx.
4.5.1 Rear Cover
Warning: Disconnect the mains power cord before you remove
the rear cover.
1. Remove the stand.
2. Remove all screws of the rear cover.
3. Lift the rear cover from the TV. Make sure that wires and
flat coils are not damaged while lifting the rear cover from
the set.
4.5.2 Speakers
Tweeters
Each tweeter unit is mounted with one screw.
When defective, replace the whole unit.
Subwoofer
The central subwoofer is located in the centre of the set, and is
mounted with three screws.
When defective, replace the whole unit.
4.5.3 Main Power Supply
Refer to Figure 4-11
for details.
Figure 4-11 Main Power Supply
1. Unplug all connectors [1].
2. Remove the fixation screws [2].
3. Take the board out.
When defective, replace the whole unit.
18750_107_100415.eps
100415
1
1
111 1
1
1
18750_108_100415.eps
100415
2
18750_109_100415.eps
100528
18750_110_100415.eps
100415
2
2
2
2
2
2
2
2
1