PART TWO: Installing the New 915B403001 Lamp
Using the lamp handle, carefully
remove the new Mitsubishi 915B403001
Lamp cartridge from the bag. DON’T
TOUCH the glass parts of the lamp.
Do a final wipe with a clean, non-abrasive,
lint-free cloth to remove any possible dust.
Insert the new cartridge into the TV
without tilting the lamp. The lamp
cartridge should slide in easily.
Gently tighten the two shiny
screws. AVOID OVER TIGHTENING as this
will trigger a warning light and your TV will
not turn on.
Replace the plastic cover and tighten the one screw. Again, avoid over tightening.
If you haven’t used gloves while changing the cartridge: WASH YOUR HANDS
immediately. If you did use gloves, dispose of them immediately
PART THREE: Disposal of the used Mitsubishi 915B403001 lamp cartridge
The used Mitsubishi 915B403001 Lamp is e-waste because of the mercury inside the
bulb. DON’T THROW IT AWAY into the common garbage. Recycle correctly
according to regulations in your area. These lamps contain mercury and should not
be included in regular garbage.
Contact your local recycling center or Recycle Your Lamp.org for help in recycling
your old lamp.
PART FOUR: Setting the lamp mode
You can prolong the life of your Mitsubishi 915B403001 Lamp by changing the lamp mode.
Using the TV remote press MENU.
Use the down arrow key to scroll to the INITIAL Menu. Press the ENTER key.
Use the right arrow key to move into the submenu and scroll across to choose
the LAMP option.
Use the down to scroll to one of the two options of STANDARD or BRIGHT. Press
the ENTER key.
The STANDARD option is suitable for most viewing conditions and since it uses a
lower wattage can prolong the life of your lamp.
SALE on Projector Bulbs at www.BulbAmerica.com
take additional 5% Off with coupon code 5PDF
To Next Page