Philips F-9308-750-0 User Manual

PHILIPS UHP F-9308-750-0 (XL-2400) h ! ^ ^ /
Replacement Lamp for Sony® HD LCD Projection Television
User Instructions
CAUTION:
Do not attempt to remove the lamp immediately after use; doing so can cause serious burns. Prior to removing lamp, switch off
the power supply to the television and wait approximately 60 minutes or more to allow for complete lamp cooling.
Avoid touching the glass portion(s) of the lamp with bare hands; fingerprints, dirt and dust may cause early lamp failure and/or
image obscurity. It is recommended that gloves be worn when replacing the lamp.
When transporting the replacement lamp, use the box that is provided to avoid breakage.
WARNING:
• To avoid overheating and/or fire, ensure that the replacement lamp is mounted securely.
• Hg - LAMP contains MERCURY, Manage in Accord with Disposal Laws. See: www.lamprecycle.org or
1-877-977-0755. j
Replacing the Lamp
Switch off power to the television and wait about two minutes until the cooling fan stops. Unplug the power
cord from the wall outlet. Allow the television to cool for at least I hour.
Remove the lamp door. Turn the knob
counterclockwise to the OPEN position and pull out
the door.
Remove the lamp unit from the television by
hooking a finger through the loop of the lamp
handle and pulling it upwards; pull the lamp straight
out.
Note: To avoid injury, exercise caution when
removing the lamp unit and do not place your hand
in the lamp storage area.
PHILIPS
SALE on Projector Bulbs at www.BulbAmerica.com
take additional 5% Off with coupon code 5PDF

Philips F-9308-750-0 Specifications

General

Model	F-9308-750-0
Category	Outdoor Light
Voltage	220-240V
Frequency	50/60Hz
Color Temperature	3000K
Beam Angle	120°
IP Rating	IP65
Material	Aluminum

Summary

User Instructions and Safety Precautions

General Cautions

Safety guidelines regarding lamp removal timing, handling, and transport.

Specific Warnings

Safety warnings about secure mounting and mercury content in the lamp.

Replacing the Lamp

Lamp Removal Steps

Instructions for powering down, cooling, and physically removing the lamp.

Lamp Installation Steps

Instructions for inserting the new lamp, securing it, and restoring power.