Replacing Philips 915B403001 lamp on Mitsubishi DLP TV series C9, 737, 837
Mitsubishi WD-82837 DLP TV
Step-by-Step Instructions for replacing the Mitsubishi 915B403001 Lamp
When the picture on your Mitsubishi starts to dim it’s time to replace the lamp. The Lamp
Indicator will also turn red. You’ll need to purchase a Mitsubishi 915B403001 lamp
replacement.
If you have a Mitsubishi series WD-60C9 /WD-65C9 /WD-73C9 / WD-60737 / WD-65737 /
WD-73737 / WD-82737 / WD-65837 / WD-73837 / WD-82837 the Lamp Indicator will be
found on the front panel just left of the Power button.
When the TV is operating normally, this indicator
will not be lit. When it turns RED, the Mitsubishi
915B403001 has reached its end of life and must
be replaced immediately; the TV will not operate
with a burnt out lamp since this is the TV’s only
light source.
The life of the Mitsubishi 915B403001 lamp can vary depending on the selected lamp mode
and how much the TV is used. The original lamp is guaranteed from one year from the date
of original purchase.
Before Installation
Be sure to purchase a genuine Mitsubishi 915B403001 Lamp Cartridge (this includes the
housing as well as the bulb) either directly from the manufacturer or from an authorized
dealer. Cheaper models may damage your set since these are often created with
counterfeit, inferior parts that will not fit or perform properly. Your warranty may also be
void if you install a lamp bought from an unauthorized source.
SALE on Projector Bulbs at www.BulbAmerica.com
take additional 5% Off with coupon code 5PDF
To Next Page
Need help?
General
