Philips AC 914 - Page 11

At the boundary of the
reception area
If you leave the area of
coverage of all programmed
transmitters, you will hear a
warning (Warnton). Moreover,
the INFO indicator will fade
and the display will show
0000’. This is relevant if the
volume control is at minimum
or during cassette playback.
You should switch to another
PROGRAMMING MCC
Programming the MCC system ]
Note: If your dealer has already
programmed the radio for you,
you can skip this chapter.
FM transmitters
Separately
packed
via
bandrole
you
will
find
a
number
of
maps.
Take
the
map
you
are
interested
in.
Each
map
gives
the
locations
of
the
FM
Turn the radio on; the display
will light up.
2 Depress the button STORE.
transmitters.
In
the
column
at
The
STORE
indicator
will
light
the
right
of
the
map
they
are
up
for
5
seconds.
INFO programme now.
Switching off the INFO: The
co-programmed INFO mode
can be switched off temporarily
by briefly depressing the INFO
button. This facility can be
uséd when you do not want a
playback of a favourite
cassette interrupted by traffic
information.
given
in
alphabetical
order.
In
the
remaining
columns
the
different
programmes
in
your
area
are
mentioned.
Select
a
programme
you
want
to
receive.
Mark
in
the
column
in
question
the
transmitter
frequencies
you
are
interested
in
(maximum
10
transmitters!);
in
other
words
transmitters
in
3
Depress
the
MCC
button
your
residential
area
or
the
before
the
light
fades.
region
you
often
visit.
The
transmitter
frequencies
which
you
have
marked
should
now
be
programmed
on
button
P1.
Repeat
this
for
the
other
programmes
on
buttons
P2
through
P6.
Volume at minimum
Turn
the
volume
to
minimum
The
display
will
snow
the
first
during
programming.
In
doing
memory
location
of
e.g.
button
so
you
will
not
be
confused
by
P4,
stations other than those you
want, including foreign
transmitters.
For
safety
reasons
and
to
io
enable
accurate
tuning,
you
MEE
STEREO
should programme only when
the car is standing still.
11