Philips AC2726 - Page 45

45EN
English
Cleaning the pre-filter
Note
• If the pre-filter is damaged, worn or
broken, do not use. Visit
www.philips.com/support or
contact the Consumer Care Center
in your country.
Filter alert light
status
Follow this
F0 displays on the
screen and wick&
pre-filter cleaning
alert goes on
Clean the pre-
filter
1 Pull the top part of the back panel
towards you to release it from the
appliance.
2 To remove the pre-filter, press the
clip down and pull the filter towards
you.
Note
• When placing the wick wheel on the
wick support, make sure that the
projections on the wick wheel falls
into the corresponding grooves.
7 Place the water tray back into the
appliance.
8 Place the water tank back into the
appliance.