Note
• Make sure that the pre-filter is
completely dry. If it is still wet, bacteria
may multiply in it and shorten the
lifetime of the pre-filter.
5 Put the pre-filter back into the
appliance.
Note
• Make sure that the side with the two
clips is pointing towards you, and that
all hooks of the pre-filter are properly
attached to the purifier.
6 To reattach the front panel, mount
the panel onto the top of the
appliance first (1). Then, gently push
the panel against the body of the
appliance (2)
1 Pull the bottom part of the front
panel to remove it from the
appliance.
2 Press the two clips down and pull
the pre-filter towards you.
3 Wash the pre-filter under a running
tap. If the pre-filter is very dirty, use
a soft brush to brush away the dust.
4 Air dry the pre-filter.
To Next Page
Loading...
