Philips AC4002 - Initial Setup Procedures; Filter Installation Guide

8
ENGLISH
- The appliance is only intended for household use
under normal operating conditions.
- Do not use the appliance in wet surroundings or in
surroundings with high ambient temperatures, such
as the bathroom, toilet or kitchen.
- The appliance does not remove carbon monoxide
(CO) or radon (Rn). It cannot be used as a safety
device in case of accidents with combustion
processes and hazardous chemicals.
Electromagnetic elds (EMF)
This Philips appliance complies with all applicable standards and regulations
regarding exposure to electromagnetic elds.
Before rst use
Placing the lters
The appliance comes with all lters tted inside, but you have to remove
the packaging of the lters before you can use the appliance. Remove all
lters, unpack them and place them back into the appliance as described
below.
Tip: Place the appliance against a wall for more stability when you remove or
insert lters.
Note: Make sure you insert the lters in the correct position.
1 Place your ngers in the recesses of the side panels and gently pull the
bottom of the front panel towards you. Then lift the hooks at the top
of the panel out of the top of the appliance.
2 To remove the pre-lter, grab the two projections and pull the lter
towards you.
3 Remove all other lters from the appliance.
1
2