Philips AC4014/80 - Getting Started; Install Filters

7
English
3 Remove all the lters from the purier.
4 Remove all packaging material from the
lters.
5 Put the lters back into the purier.
3 Getting started
Installlters
The air purier comes with all lters tted
inside, but you have to remove the packaging
of the lters before you can use it. Remove all
lters, unpack them, and place them back into
the air purier as described below.
Tip
•
When you remove or insert lters, place the
purier against a wall for more stability.
Note
•
Insert the lters in the correct position.
• Make sure you place the lters in the order of
HEPA lter, activated carbon lter, and nally the
pre-lter.
• Make sure that the side with the tag is pointing
towards you.
1 Place your ngers in the recesses of the
side panels and gently pull the top part of
the front panel towards you.
2 Gently pull the bottom of the panel out
(1), then lift the top part of the front
panel towards you (2).
1
2
EN
English