Philips AC4025 - Filter Replacement; Replacing Activated Carbon and HEPA Filters

13EN
Note
•
Insert the lters in the correct position.
• Make sure you place the lters in the order of HEPA
lter and activated carbon lter.
• Make sure that the side with the tag is pointing
towards you, and the tag is at the bottom end of
the lter.
1 Switch off the purier and unplug it.
2 Place your ngers at the top panel and
gently pull the top part of the front panel
towards you (1).
3 Lift the panel out of the hooks at the
bottom of the purier (2).
1
2
6 Replace the
filters
The lter replacement light ( ) indicate the
lter have to be replaced.
Replace the activated carbon
lterandtheHEPAlter
Note
•
The activated carbon lter and the HEPA lter are
neither washable nor vacuum cleanable.
Replace both the activated carbon lter and
HEPA lter when the
light starts to ash.
This will last for approximately 2 weeks.
When you do not replace the lter in time:
» The
lights up continuously.
In sleep mode, when the light starts to
ash but dim, replace both the activated
carbon lter and HEPA lter. This will last for
approximately 2 weeks.
When you do not replace the lter in time:
» The
lights up but dim continuously.
Tip
•
When you remove or insert lters, place the purier
against a wall for more stability.
EN
English