Philips AC6601 - Switch on; Understand the Air Quality Light; Using the Appliance

26 EN
5 Put the pre-lter back into the
appliance.
Note
• Make sure that the side with the
two clips is pointing towards
you, and that all hooks of the
pre-lter are properly attached
to the purier.
6 To reattach the side panel,
mount the panel onto the
bottom of the appliance rst
(1). Then, gently push the
panel against the body of the
appliance (2).
7 Repeat the above steps and
assemble the air purication
lter for the other side of the
appliance.
4 Using the
appliance
Understand the air
quality light
Color of the air
quality light
Air quality
level
Blue Good
Blue-Purple Fair
Purple-Red Unhealthy
Red Very
unhealthy
The air quality light automatically
goes on when the appliance is
switched on, and lights up all colors
in sequence.
In a short time the air quality
sensors select the color that
corresponds to the ambient air
quality.
Switch on
1 Put the plug of the appliance
into the wall socket.
» The appliance beeps.
» All lights go on once and
then go out again.