20
Update from the
Warning
Always connect your AD7000W to AC power for
Note
To use an Internet browser other than Apple Safari
on your PC/Mac, remember to go to the Wi-Fi router
your AD7000W. See the user manual of your Wi-Fi
connected to the Wi-Fi router.
1 Power on AD7000W (see ‘Turn
AD7000W on’ on page 9).
» It takes about 35 seconds for the unit
to boot up. During boot-up, the WI-FI
SETUP indicator on the back of the
unit blinks green quickly.
» After boot-up, you can hear a beep
and the WI-FI SETUP indicator
turns to green steadily. AD7000W is
network automatically.
2 Make sure that AD7000W and your PC/
Mac are connected to the same Wi-Fi
router.
3 Open Apple Safari on your PC/Mac, then
select ‘Philips_Fidelio XXX’ from the
Bonjour pull-down list.
Or open any other Internet browser
on your PC/Mac, then type in the IP
address of AD7000W (available on
at the address bar.
»
web page is displayed.
6 Update
firmware
Note
!
1 On your PC/Mac, go to www.philips.com/
support.
2
3
www.philips.com/support
XXXX
XXXX. zip
EN
To Next Page
Loading...
