Troubleshooting
If a fault occurs, first check the points listed below before taking the set for
repair.
If you are unable to remedy a problem by following these hints, consult
your dealer or service centre.
WARNING: Do not open the set as there is a risk of electric shock. Under
no circumstances should you try to repair the set yourself, as this will
invalidate the guarantee.
Problem
– Possible cause
• Remedy
No sound /power
– Volume not adjusted
• Adjust the VOL.
– Batteries dead/ incorrectly inserted
• Insert (fresh) batteries correctly
– Headphones connected to the set
•
Disconnect headphones.
Poor radio reception
– Weak radio signal
• For MW, the set uses a built-in antenna. Direct this antenna for best
reception by turning the whole set.
Display does not function properly / No reaction to operation of
any of the controls
– Electrostatic discharge
• Switch off and unplug the set. Reconnect after a few seconds.
To Next Page
