No sound.
–Volume not adjusted.
• Adjust the VOLUME.
Display error / no reaction to any
controls.
– Electrical malfunction
• Press RESET hole on the bottom of the set with
a ball pen.
Occasional crackling sound during FM
broadcast.
–Weak signal.
• Extend the pigtail antenna fully.
The alarm does not function.
– Alarm time not set.
•
See section on Setting alarm time
.
– Alarm mode not selected.
•
See section on Setting alarm mode
.
–Volume too low for radio.
•
Increase the volume.
The main unit cannot read or update out-
door temperatuare from the sensor
– No signal or weak signal.
• Reset both the main unit and the sensor. Or
improve the sensor reception. See “ Using the
sensor to detect outdoor temperature”.
Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or
service center.
WARNING:
Do not open the set as there is a risk of electric shock. Under no circum-
stances should you try to repair the set yourself, as this will invalidate the warranty.
CAUTION
High voltage! Do not open.You run the risk of getting an electric shock.The
machine does not contain any user-serviceable parts.
Modification of the product could result in hazardous radiation of EMC or
other unsafe operation.
To Next Page
Loading...
