Note
• You can only use AC power as power supply. The pre-installed
lithium CR2032 battery can only back up time and alarm.
• When power is disconnected, the display backlight is off.
For rst-time use:
Remove the protective tab to activate the battery.
To replace the battery: B
Connect power C
Caution
• Risk of product damage! Ensure that the power voltage corresponds
to the voltage printed on the back or underside of the clock radio.
• Risk of electric shock! When you unplug the AC adapter, always pull
the plug from the socket. Never pull the cord.
Set clock
1 In standby mode, press and hold SET for two seconds to
activate clock setting mode.
» [12H] or [24H] is displayed.
2 Press TUNING +/- or / repeatedly to select 12/24 hour
format.
3 Press SETagaintoconrm.
» The hour digits begin to blink.
4 Repeat Steps 2 to 3 to set the hour and minute.
To Next Page
