Note
You can only use AC power as power supply. The pre-installed •
lithium CR2032 battery can only back up time and alarm.
When power is disconnected, the display backlight is off.
•
For fi rst-time use:
Remove the protective tab to activate the battery.
To replace the battery: B
Connect power C
Caution
Risk of product damage! Ensure that the power voltage corresponds •
to the voltage printed on the back or underside of the clock radio.
Risk of electric shock! When you unplug the AC adapter, always pull
•
the plug from the socket. Never pull the cord.
Set clock
1 In standby mode, press and hold SET for two seconds
to activate clock setting mode.
» [12H] or [ 24H] is displayed.
2 Press TUNING +/- or / repeatedly to select 12/24
hour format.
3 Press SET again to confi rm.
The hour digits begin to blink. »
4 Repeat Steps 2 to 3 to set the hour and minute.
To Next Page
Loading...
