Philips AS660C/41 - Page 6

§S0 06 SOd
General Information/Safety Information _
General Internation
‘+The typepat is locate atthe rear ofthese,
‘Recording is pennissible if copyright or other rights of third
partes are not infringed,
1. Allunnesessary packaging material hes ben omitted. We
have done our utmost to make the packaging easy to
seperate into three mano-materiais:
cardboard (box)
= exoandable polystyrene (outer)
polyethylene bags, protective foam sheet.
Please observe the local eguitions regarding the dissal
of these packaging materials.
2 Your set consists of materials which can be recycled and
reused if cisessembled by a specialized company. Pease
follow local egulations on recycling your od set.
3. Donat dispose of dead batteries with your household
‘waste, Dispose of batteries according to focal regulations.
4 Note: Switching off th standby made overnight remove the
AC power cord from the wall socket will save energy
Safety interatlon: ©
‘Before operating the system, check tha the operating
voltage indicted onthe typeplate for the voltage indication,
beside the voltage selector of your system is identical with
‘the voltage of your local power suoply. If nat, plese consult
your dealer. Th type pat is located at the rear of your
stem,
‘+ When th system is switched on, do nat mave it around.
+ Pace the system ona solid base leg. a cabinet)
‘+ Place the system in a locaton with adequate ventilation to
‘prevent internal heat build-up in your system.
‘© Donot expose the system to excessive moisture, rain, sand
‘orheat sources.
‘+ Under no circumstances should you repair the unit yourself
as this will invalidate the warranty!
‘+ Ifthe system is brought cireci from a cold toa warm
location, ois placed in avery damo room, moisture may
‘condense onthe lens ofthe CD unit inside the system.
Should this occur, the CO player wil not operate normaly.
Leave the ower on for about one hour with nods inthe
‘sit until normal playback is possible,
‘+ Electrostatic discharge may cause unexpected problems.
See whether these problems dsepoear if you unplag the AC
‘ower cord end plug it in agein efter afew seconds
‘+ To disconnect the system from the power supply
‘completely, withdraw the AC power cord from the
wall socket.
"Preparations
~ Remote contol ransmiter
Bates for enate cont! traismittr
= AMoop antenna
~ FM antenna wire
~ AC power cord
Anseitilig the batteries ints the Remote Controt
+ Inger the batteries {Type 03, UM or AAA for AS7EOCY
ASTBSC and Type RB, UM3 or AA fox ASEBOC/ASEEEC) into
‘ha remote conto! transite as shown i the battery
compartment
+ To avoid damage from possible battery leakage, remove the
batovis if extausted or unused for extended period. For
replacement use only batterie ofthe type P3, UM or
‘AAA for ASTBOC/ASTESC and type 8, UM 0 A for
ASGBOC/ASEEEC.
Preparations
@® AM Antenna Connection
Connect the supplied foop antenna tothe AM AERIAL terminal
‘Aajust the position ofthe AM loop antenna forthe best reception,
© FM Wire Antenna Connection
Connect the supotied FM wire antenna to the FM 75 © terminal
‘Adjust the postion ofthe FM antenna forthe best reception.
‘Outdoor Antenna
For better FM stereo reception connect an outdoor FM antenna
to the FM AERIAL 75.9 terminal using @ 75 02 coaxial wire.
© Speaker Connections
‘+ Connect the right speeker to terminal , withthe ed wire to
“+ andthe black wire to —
‘© Connect the lft speaker to terminal L withthe red wire to
+ and the black wire to —
‘+ Clip the stripped portion of the speaker wire as shown,
© Connecting other equipment to your system
‘You can connect TV, Laser Disc or VCR audio left and right
‘outputs to the AUX/TV IN terminal atthe rear ofthe system.
© Phono In (ASG60C and AS760C only)
You can connect a record playar with magnetic cartridge. The
‘round wire should be connected to the screw marked GND,
® Adjusting the Operating Voltage
{for specie version only)
Before connecting the AC power cord to a wall outlet, make sure
thatthe voltage selector at the ear of the system s set to the
local powerline voltage. I not, reset the selector before
‘connecting tothe wall outlet.
© AG Power Supply
Ater al other connections have been made, connect the AC
ower socket to tha set and the AC power plug tothe wall
outlet
HSN YOS NOILONYLSNI
ve