Philips AVENT SCD503 - Using the baby monitor; 5.1 Positioning the baby monitor; 5.2 Linking parent unit and baby unit

6
• To prevent a high-pitched sound from one
or both units, make sure the parent unit is at
least 1.5 metres/4.9 feet away from the baby
unit.
5.2 Linking parent unit and
baby unit
1 Press and hold the 3 button on the baby unit
for 3 seconds until the power-on light lights
up.
2 Press and hold the 3 button on the parent
unit for 3 seconds until the ‘link’ light starts
ashing red.
3 To reattach the battery compartment lid, rst
insert the lugs into the bottom rim of the
battery compartment. Then push the lid home
until it locks into place with a click.
5 Using the baby
monitor
5.1 Positioning the baby
monitor
B Warning:
Keep the baby unit out of the reach of the baby.
Never place the baby unit inside the baby’s bed
or playpen.
• Because the cord of the baby unit presents
a potential strangulation hazard, make sure
that the baby unit and its cord are at least 1
metre/3.5 feet away from your baby.