Philips AWP1775WH - Water Outlet; Product Introduction; Installation; Maintenance

2 EN
— If the lter is not used for 2 days, let the water run about a minute before
use again.
— If the lter is not used for more than a week, remove and drain the cartridge.
Wrap and store it in the chiller of the fridge. Let the water run for 3 minutes
before use again.
— If the lter has been used for a long time and water ow obviously decreases,
remove the cartridge and shake it, then ush it with water from both ends.
— Replace the cartridge every 6 to 12 months based on the tap water quality
and usage frequency. The model number is AWP175.
3 Maintenance
— This product is for tap water only. Do not use water of unknown source.
— Do not install it if the water supply is with water pressure exceeding 0.4MPa.
— If the pressure exceeds 0.4MPa, pressure-reducing valve should be added
which needs to be purchased separately.
— The inlet water temperature should be 5-60°C, otherwise the cartridge will
be damaged.
— The water treated by this product is for showering only. Do not drink the
water ltered by it.
— The cartridge can only be cleaned with water. No detergents should be
used because they will damage the lter."
4 Precautions
This product includes a 2-year warranty from the date of purchase. For more
detail about warranty conditions, please visit: www.Philips.com.
Within two years from the date of purchase, you will receive free warranty
against defects in materials and workmanship, when used in compliance with
the user manual and conrmed by our maintenance service.
The warranty service does not include frequent replaced consumable
components (lter cartridge, granular activated carbon, ion exchange resin,
hollow ber membrane, etc.), auxiliary devices, transportation fee and
door-to-door service.
5 Warranty
1 EN
This product is mainly used for shower ltraion. Municipal tap water is used
as water supply. It does not need door-to-door installation. Please install it
according to this user manual.
1 Product Introduction
2 Installation
3
4
2
1
Take out the lter cartridge
and remove the covers at
both ends of the cartridge.
Put the cartridge back in the case.
Turn on the tap for 2-3 minutes
to check if there is any leakage.
Connect the hose to the water outlet
end of the lter.
Remove the hose from the water
mixing valve, and connect and tighten
the shower lter with the valve from
the water inlet end.
1
2
2
4
1
3