EasyManua.ls Logo

Philips AWP3703 - Operational Use and Maintenance; Initial Use and Flushing; Daily Water Mode Selection; Routine Daily Maintenance

Philips AWP3703
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Always use cold water (5-38) for the filtered mode. Otherwise the filter will be
damaged.
2. Maintenance
Daily maintenance
When to replace:
Based on the daily usage assumption, the filter should be replaced:
· every 5-6 months for 1 person
· every 2-3 months for 2 persons
· every 1-2 months for 3 persons
Filter replacement
3
Notes
For the first time use, select the unfiltered mode and let the water run for 5 seconds.
Then switch to the filtered mode and let the water water run through the filter for 3 minutes.
Daily usage
AWP3703, AWP3753:
Press the PUSH button to switch between filtered and unfiltered mode.
- Unfiltered shower mode
Press the PUSH button to select the mode
- Filtered stream mode
Press the PUSH button again to select the mode.
AWP3704, AWP3754:
Turn the lever to switch among the filtered stream, unfiltered shower and unfiltered
stream mode.
- For everyday usage: extract unfiltered water for 5 seconds before switching to to
prevent filter from being clogged, and extract filtered water for 5 seconds before usage.
- If it hasn't been used for more than 2 days, extract the filtered water for 20 seconds
before usage.
- If it hasn't been used for more than 2 weeks, extract the filtered water for 3 minutes
before usage. If there is odor found in the filtered water, please change the filter cartridge.

Related product manuals