11
English
Synchro Start CD recording
1 Select CD source.
2 Insert a CD and if desired,programme
track numbers.
3 Press STOP•OPEN 9/ to open the
cassette door.Insert a blank tape.
4 Close the cassette door.
5 Press RECORD 0 to start recording.
• Playing of the CD programme starts
automatically from the beginning of the
programme. It is not necessary to start the
CD player separately.
6 For brief interruptions press PAUSE ;.To
resume recording,press PAUSE ; again.
7 To stop recording,press STOP•OPEN 9/.
Selecting and recording a particular
passage
• During CD playback,press and hold down
the SEARCH buttons ∞ or § on the set
to find your passage.
• Press PLAY•PAUSE 2; to put the CD
player on pause at the selected passage.
➜ Recording will begin from this exact
point in the track when you press
RECORD 0.
Recording from the Radio
1 Select RADIO source and your waveband.
2 Tune to the desired radio station (see
Radio reception).
3 Press STOP•OPEN 9/ to open the
cassette door.Insert a blank tape.
4 Close the cassette door.
5 Press RECORD 0 to start recording.
6 For brief interruptions, press PAUSE ;.To
resume recording,press PAUSE ; again.
7 To stop recording,
press STOP•OPEN 9/.
Precautions &
General Maintenance
• Place the set on a hard and flat surface so
that the system does not tilt.
• Do not expose the set,batteries,CDs or
cassettes to humidity,rain,sand or excessive
heat caused by heating equipment or direct
sunlight.
• Do not cover the set.Adequate ventilation
with a minimum gap of 6 inches between
the ventilation holes and surrounding
surfaces is necessary to prevent heat build-
up.
• The mechanical parts of the set contain
self-lubricating bearings and must not be
oiled or lubricated.
• To clean the set, use a soft,slightly
dampened chamois leather.Do not use any
cleaning agents containing alcohol,
ammonia,benzene or abrasives as these
may harm the housing.
Recording Maintenance