13
English
If a fault occurs,first check the points listed below before taking the set for repair.
Do not open the set as there is a risk of electric shock.
If you are unable to remedy a problem by following these hints,consult your dealer or
service centre.
WARNING:Under no circumstances should you try to repair the set yourself,as this
will invalidate the guarantee.
Troubleshooting
Problem Solution
No sound – Adjust the VOLUME
No power – Mains lead not securely connected.
Connect AC mains lead properly
– Batteries exhausted /incorrectly inserted.
Insert (fresh) batteries correctly
Display does not function – Electrostatic discharge
properly/ No reaction to Switch off and unplug the set.
operation of any of the Reconnect after a few seconds.
controls
no d1SC,Cd Err or – No CD inserted,insert a CD
nF d1SC indication – CD badly scratched/ dirty.
Replace/ clean CD (see maintenance)
– CD-R(W) is blank or the disc is not finalized.
Use a finalized CD-R(W)
– Laser lens steamed up.Wait until lens has acclimatized
Laser lens steamed up – Wait until lens has cleared
– Wait until lens has acclimatized
CD playback does not work – CD badly scratched/ dirty.
Replace/ clean CD (see maintenance)
The CD skips tracks – CD damaged or dirty.Replace or clean CD.
– Programme is active.Quit programme mode
Poor cassette sound quality – Dust and dirt on the heads,etc.
Clean deck parts,see maintenance.
– Use of incompatible cassette types (METAL or
CHROME).Only use NORMAL (IEC I) for recording
Recording does not work – Cassette tab(s) may be broken.
Apply a piece of adhesive tape over the missing tab space.
AZ101801 19-12-2000 18:50 Pagina 13
To Next Page
Loading...
