English
13
If a fault occurs, first check the points listed below before taking the set for repair. Do
not open the set as there is a risk of electric shock.
If you are unable to remedy a problem by following these hints, consult your dealer or
service centre.
WARNING: Under no circumstances should you try to repair the set yourself, as this
will invalidate the guarantee.
Troubleshooting
Problem Solution
No sound – Adjust the VOLUME
No power – Mains lead not securely connected.
Connect AC mains lead properly
– Batteries exhausted /incorrectly inserted.
Insert (fresh) batteries correctly
Display does not function – Electrostatic discharge
properly/ No reaction to Switch off and unplug the set. Reconnect after a few
operation of any of the seconds.
controls
Er indication – No CD inserted, insert a CD
– CD badly scratched/ dirty.
Replace/ clean CD (see maintenance)
– CD-R(W) is blank or the disc is not finalized.
Use a finalized CD-R(W)
– Laser lens steamed up.
Wait until lens has cleared/acclimatized
CD playback does not work – CD badly scratched/ dirty. Replace/ clean CD (see
maintenance)
The CD skips tracks – CD damaged or dirty. Replace or clean CD.
– Shuffle is active. Quit shuffle mode
Poor cassette sound quality – Dust and dirt on the heads, etc.
Clean deck parts, see maintenance.
– Use of incompatible cassette types (METAL or
CHROME). Only use NORMAL (IEC I) for recording
Recording does not work – Cassette tab(s) may be broken.Apply a piece of
adhesive tape over the missing tab space.
AZ1080/01 03/07/02 11:31 Page 13
To Next Page
Loading...
