Philips AZ1880/12 - Select Power Supply

10
2 ConnecttheotherendoftheAC
adaptortothewalloutlet.
Battery power
1 Openthebatterycompartmentonthe
bottomoftheunit.
2 Insert6R14/UM2/CCellbatteries(not
included)withcorrectpolarity(+/-)
asindicated,thenclosethebattery
compartment.
3 Theunitisreadytooperate.
3 Closethebatterycompartment.
Note
Ifyouarenotgoingtousetheremotecontrol •
foralongtime,removethebattery.
Batterycontainschemicalsubstances,soit
•
shouldbedisposedofproperly.
Select power supply
TheunitcanbeoperatedbyACpoweror
batteries.
AC power
Caution
Riskofproductdamage!Ensurethatthe •
powersupplyvoltagecorrespondstothe
voltageprintedonthebottomoftheunit.
Riskofelectricshock!Whenyouunplugthe
•
ACadaptor,alwayspulltheplugfromthe
socket.Neverpullthecord.
BeforeconnectingtheACadaptor,ensureyou
•
havecompletedallotherconnections.
Note
Thetypeplateislocatedonthebottomofthe •
mainunit.
1 ConnectoneendoftheACadaptorto
theDC INsocketonthemainunit.
EN
AZ1880_12_Book 1.indb 10 2009-8-10 16:04:19