Provided the current time has been set, your player can be used as an alarm clock.
1 Keep SET· pressed for approximately 2 seconds, then briefly press SET· again.
y AL is displayed and the alarm clock digits 00:00 flash.
2 Press 3 or 4 repeatedly within 5 seconds to set the alarm time.
y is shown and the alarm time is displayed.
3 Press SET· twice or do not press any key for 5 seconds.
y The alarm time is set and the alarm display goes off.
• To switch to the alarm clock display during CD or tuner play, press CLOCK twice.
y is shown and the alarm time is displayed for 5 seconds.
Alarm time setting
Your player has a built-in clock. However CD or tuner play is not conditional upon the
time setting.
1 Keep SET· pressed for approximately 2 seconds.
y The clock digits OO:OO flash.
2 Keep 3 or 4 pressed, then briefly press 3 or 4 again repeatedly within 5 seconds to
set the current time.
y The current time is displayed.
3 Press SET· three times or do not press any key for 5 seconds.
y The current time is set and the time display goes off.
• To switch to the clock display during CD or tuner play, press CLOCK.
y The current time is displayed for 5 seconds.
Notes: – When the player is supplied by batteries do not remove the batteries during
radio play, otherwise time settings will be lost and will have to be readjusted.
– If the power supply is interrupted for longer than 1 minute, all time settings
will be lost and will have to be readjusted.
Time setting
ESP
PROGRAM
RADIO ·BAN
D
·M
O
D
E
You can store up to 30 radio stations.
1 Tune to a desired radio station and press PROGRAM.
2 Press ∞ or § if necessary repeatedly to select the number that should be assigned to
this radio station.
3 Press PROGRAM while
PRESET is blinking to confirm the storing.
y PRESET, the waveband, the frequency and the preset number of the stored station
are displayed.
4 Store all desired stations this way.
Note: Already stored stations can be recognized by the indicator
PRESET
and the preset
number.
Tuning to a stored radio station
1 Select the waveband.
2 Press ∞ or § if necessary repeatedly to select the preset number of the desired radio
station.
y Radio play starts. PRESET, the waveband, the frequency and the preset number of
the stored station are displayed.
Storing radio stations
1-5
CS 46 691
To Next Page
Loading...
