INSTRUCTION FOR USE (excerpt)
• FM: The headphone wire is used as FM antenna.
If necessary move it for optimum reception.
• MW: The internal MW antenna is directed by turning the player.
Antennas
You can tune to any FM or MW station automatically or manually.
Stereo stations are indicated by
ST.
1 Press RADIO·BAND to switch the radio on.
2 Press RADIO·BAND if necessary repeatedly to select the desired waveband.
y FM 1, FM 2, FM 3, FM 4 or MW is shown.
Tuning to radio stations automatically
1 Keep 3 or 4 pressed for at least 1 second.
y The radio tunes to a station with sufficient strength and radio play starts.
A (for “automatic search”) and the current waveband and frequency are displayed.
2 Repeat searching until you find the desired radio station.
Tuning to radio stations manually
1 Keep 3 or 4 pressed.
2 Release 3 or 4, then briefly press 3 or 4 again when you are close to the desired
frequency.
3 Briefly press 3 or 4 repeatedly until you reach the desired frequency.
y Radio play starts. The current waveband and frequency are displayed.
• To switch from radio play to CD play press 2;.
• Press 9 to switch the radio off.
Note: In case of interferences in stereo mode press ·
MODE
to switch to mono.
Radio play
P
RO
G
RA
M
CLOCK
RADIO·BAND
SET·
You can select up to 99 tracks and store them in memory in a desired sequence.
Any track can be stored more than once.
1 While playback is stopped, select a track with ∞ or §.
2 Press PROGRAM to store the track.
y PROGRAM lights up; the track number programmed and P with the total number of
stored tracks are displayed.
3 Select and store all desired tracks in this way.
4 Press 2; to start playback of your selected tracks.
y PROGRAM is shown and playback starts.
• You can review the program by pressing PROGRAM for more than 2 seconds.
y The display shows all stored tracks in sequence.
Notes: – If you press
PROGRAM
and there is no track selected,
SELECt
is displayed.
– If you try to store more than 99 tracks,
FULL
is displayed.
Clearing the program
1 If necessary, press 9 to stop playback.
2 Press 9 to clear the program.
y CLEAr is displayed once, PROGRAM goes off and the program is cleared.
Notes: The program will also be cleared if you
– interrupt the power supply or
– open the CD lid.
Programming track numbers
1-4
CS 46 690
To Next Page
Loading...
