It also prevents any excess water from the humidifier
passing through your tubing and dripping onto your face
during the night.
6. Fill your humidifier water tub (if applicable), by
following the instructions below:
• Pull the latch on the front and lift open the lid.
• Remove the water tub from the unit.
1. Align your humidifier with the A30/40 unit and push
them together until they click into place.
• Fill the tub to the maximum mark with boiled
water that has cooled down.
• Place the tub back into the unit.
2. Connect the DC plug of the power supply unit to the
rear of your Bipap
®
A30/40 unit.
• Close down the lid ensuring that you hear it click
into place.
3. Connect the power cord to the power supply unit and
plug the other end of the power cord into a mains power
outlet.
4. Connect your air tubing firmly into the air outlet.
5. Connect your mask to the other end of the air tubing.
The mask shown is for illustration purposes only.
Your own mask may differ from this.
7. Turn the mains power on and press the button
once. Your Bipap
®
A30/40 unit should now show the
current date and time, as seen here. This is your home
screen.
4 5
To Next Page
Loading...
Need help?
General
