BiPAP A40 user manual
34
4.4.1 Using AC Power
An AC power cord and power supply is included with the device.
1. Plug the socket end of the power cord into the power supply.
2.
Plug the pronged end of the power cord into an electrical outlet that is not controlled by a wall switch.
3. Plug the power supply cord’s connector into the power inlet on the back of the ventilator.
4. Ensure that all connections are secure.
5. There is an accessory clip that can be used to secure the power cord to prevent accidental
disconnection. Route the cord through the clip and secure the clip to the enclosure of the
device using the supplied screw, as shown.
1
2
3 4
Note: Some devices have a locking-type power connector. To avoid damage to the connector, when disconnecting
the power cord, pull the connector at its base, not the cord, to disengage the lock.
To Next Page
Loading...