Selecting the treatment modes
The BlueTouch Pain Relief Patch has three modes and an OFF setting.
You have to press the mode button one or more times to select one of
the three treatment modes. When you press the mode button a fourth
time, you switch off the BlueTouch Pain Relief Patch.
1 Mode 1 (low): press once
2 Mode 2 (medium): press twice
3 Mode 3 (high): press three times
4 O (OFF): press four times
Note: If you want to switch from mode 3 to mode 1 or 2 or from mode 2 to
mode 1, you have to press the mode button as many times as required to
reach the mode you want to select.
Note: If you select another mode by switching through the OFF setting within
2 seconds, the treatment timer is not reset to the treatment of the newly
selected mode but continues to count down at the point where you switched to
the other mode. This means that the remaining treatment time is recalculated
for the intensity and the treatment time of the newly selected mode.
For example, if you switch from mode 3 to mode 1 and the remaining
treatment time in mode 3 was 5 minutes, the remaining treatment time in
mode 1 is 10 minutes. In mode 1 the intensity is 50% of that in mode 3,
which means that the treatment in mode 1 lasts twice as long as in mode 3.
Treatment intensity
When you select a treatment mode, you get audible and visible feedback.
, In mode 1 (low), two rows of LEDs light up. The BlueTouch Pain
Relief Patch beeps once.
, In mode 2 (medium), four rows of LEDs light up. The BlueTouch Pain
Relief Patch beeps twice.
, In mode 3 (high), six rows of LEDs light up. The BlueTouch Pain Relief
Patch beeps three times.
, After you select a mode, the BlueTouch Pain Relief Patch switches
on in power-save mode. In this mode all LEDs are on at their lowest
intensity.
, When you place the BlueTouch Pain Relief Patch on the skin, treatment
starts at the intensity of the mode selected (100% for mode 3, 75% for
mode 2 and 50% for mode 1) and you get audible feedback.
Preparing the BlueTouch Pain Relief Patch for use
The preferred method for fastening the Pain Relief Patch to the body is by
means of one of the BlueTouch Pain Relief straps. There is a special strap
for treatment of the upper back and a special strap for treatment of the
lower back.
- Lower back straps are available separately under type number PR3083,
depending on your size.
Medium HighLow
Off
1 2 3 4
ENGLISH18
To Next Page