Philips CD163 - Page 3

INSTALLATION
GIGSTAL AUGIO
PHILIPS
ACCESSORIES (for CD165 only)
Certain versions of this player are equipped with a
voltage selector, which enables you to set the player to
the correct mains voltage yourself.
Remote control;
Batteries (2x AAA size) for remote control.
POWER SUPPLY SETTING
Check that the type plate on the bottom of your
player indicates the correct power voltage.
If your power supply voltage is different, consult
your dealer or our Service Organisation.
CONNECTIONS
1 ANALOG OUT
For the connecting cable to the amplifier or HiFi
system.
Insert a red plug into the 'R' jack and the other
plug into the 'L' jack of the CD or AUX input of
your amplifier or HiFi system.
You can also use the TUNER or TAPE IN con-
nection, but never the PHONO input!
RC5-IN (Remote In) (for CD163 only)
For connecting up the equipment when you are
incorporating the player in the amplifier or HiFi
system with RCS.
Voltage selector (not all versions)
See ‘Power supply setting’.
Important notes for users in the U.K.:
Mains Plug
This apparatus is fitted with an approved moulded 13 Amp
plug.
To change a fuse in this type of plug proceed as follows:
¢ Remove fuse cover and fuse.
e Fix new fuse which should be a BS1362 5A, A.S.T.A. or
BSI approved type.
© Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it
should be cut off and an appropriate plug fitted in its place.
If the mains plug contains a fuse, this should have a value of
5 A. Ifa plug without a fuse is used, the fuse at the distribution
board should not be greater than 5 A.
Note:
The severed plug must be destroyed to avoid a possible
shock hazard should it be inserted into a 13 A socket else-
where.
How to connect a plug
The wires in the mains tead are coloured with the following
code: blue = neutral (N), brown = live. (L)
As these colours may not correspond with the colour mark-
ings identifying the terminals in your plug, proceed as fol-
lows:
¢ Connect the blue wire to the terminal marked N or col-
oured black.
* Connect the brown wire to the terminal marked L or
coloured red.
¢ Donotconnect either wire to the earth terminal in the plug,
marked E (or 4) or coloured green {or green and yellow).
Before replacing the plug cover, make certain that the cord
grip is clamped over the sheath of the lead — not simply over
the two wires.
Copyright:
Recording and playback of material may require consent. See
Copyright Act 1956 and The Performer's Protection Acts
1958 to 1972.
PCS 64 109