Philips CSS2133B/F7 - Resetting to factory settings

13
English
EN
Apply factory settings
You can reset your SoundBar to the default
settings programmed at the factory.
1 Press BASS+, VOL-, and Treble+ within
three seconds.
» When the factory settings restore is
complete, the SoundBar automatically
switches off and restarts.
5 Wall mount
Note
• Koninklijke Philips Electronics N.V. bears no
responsibility for improper wall mounting that results
in accident, injury or damage. If you have any query,
contact Philips Consumer Care in your country.
• Before wall mounting, make sure the wall can support
the weight of your SoundBar.
• Before wall mount, you need not remove the two
rubber feet at the bottom of the SoundBar, otherwise
the rubber feet cannot be xed back.
Screw length/diameter
Depending on the type of wall mounting your
SoundBar, make sure that you use screws of a
suitable length and diameter.
For information about how to wall mount your
SoundBar, see the quick start guide.
> 25mm
3-4mm
4mm
CSS2133B_F7_UM_V1.0.indb 13 2013/2/22 17:15:21