Philips DCC 170 - Automatic Reverse Marker Recording; Manual Reverse Marker Recording

English
RECORDING OF MARKERS
RECORDING A REVERSE MARKER
AUTOMATIC RECORDING OF A REVERSE MARKER
♦ Slide the REV MODE switch to position: ~D.
^ The selected reverse mode will be shown on the
display when the recording pause mode is selected.
1 Os 00 RecP
ABS AUTO □
ir - « =• ■ • •
• During recording of side A the DCC170 will write a reverse
marker before the end of side A. The tape will be reversed
automatically and recording will be continued on side B.
The tracknumber will be increased by one.
Reverse t-o E
_ □
6 30s12 Rec
A BS □
<icc * I r>
Caution:’\\\e DCC 170 reverses the tape direction before
the end of side A upon detection of remaining space on the
tape. In case the DCC 170 can not detect this remaining
space, recording will be continued until the end of side A.
Then the direction will be reversed, a LEAD IN area will be
written and recording on side B will start with track number
1 .
MANUAL RECORDING OFA REVERSE MARKER
1. Select the recording pause mode (by sliding the REC
PAUSE switch to the right) at the position on side A where
you want to write a reverse marker.
5 25s17 ReoP
crga ABS AUTO □
2 . P ress the MKR MODE key once.
The display will show: _
Reverse MKR ?
rwwTE: D
<?cc i:
3. P ress the MKR WRITE key.
The DCC 170 will now write a reverse marker and reverse
to side B. _
Reverse MKR 1
AUTO WITE O 1
<fcc lil!* it J •»»:<«'
Reverse to B
^ □
dec » » ’ ■ • > >» =
The recording pause mode will be entered again.
The display will show:
^ 25s18 ReeP
Psaa ABS AUTO □
dec - 1 " • * ^ ™ -
4. P ress the PLAY/SIDE ◄ ► key to continue recording on
side B
/Vo/e; Manual recording of a reverse marker acts regard¬
less of the position of the REV MODE switch. Even when
the REV MODE switch is set to position IZ. ,the above
procedure remains unchanged.
18