Philips DCC 300 - Track Renumbering Function; Using the Next Side Marker; Erasing Tape Markers; Renumbering DCC Tracks

A
‘NEXT
MARKER’
marks
the
end
of
the
last
music
track
on
this
side.
29
Vou
notice
that
there
is
no
more
room
on
the
current
side
for
the
next music track (e.g. no. 6) and you therefore want to
continue the recording at the beginning of the second side.
Interrupt the recording by pressing the
RECORD PAUSE key.
Press the WRITE MARK key to write a “NEXT MARKER’.
The unit writes a ‘NEXT MARKER’, winds to the end of the
tape, changes the side and writes a ‘LEAD IN MARKER’
(see illustration).
Continue recording by pressing the RECORD key.
The continued recording will be included in the track-
numbering as track no. 1.
LEAD IN NEXT MARKER
LEAD IN
‘LEAD
IN’
marks
the
beginning
of
the
tape
on
side
A
and
side
B.
Marker erase
16
Find the marker to be erased using the display.
Press
the
MARK
ERASE
key
just
before
or
on
the
marker
to
be
erased.
The unit erases the selected marker.
lf
the
unit
does
not
find
a
marker
within
2.5
seconds,
it
switches
to
the
previous
mode
(‘PLAY’
or
‘STOP’).
After you have erased a marker the sequence of
tracknumbers
has
been
changed.
Press
the
RENUMBER
key to correct the tracknumbering.
Select the ‘RENUMBER’ function to update the sequence
of tracks of the ‘DCC’, when the correct sequence of
tracknumbes has been changed due to adding an extra
startmarker or erasing a startmarker. |
Caution: This process may take a few minutes.
@ Press the RENUMBER key only for ‘DCC user-recorded’.
The unit winds to the beginning of side Aand then checks:
both sides for their tracknumbers. If a tracknumber is
incorrect or if a marker is badly set, they are corrected. The
unit winds to the beginning of the first music track on
side A and switches to ‘STOP’.
This function should not be interrupted.
The audio signal is muted.
While the cassette is being rewound to the beginning,
the display panel shows:
Att
PPT GE dha Tee
PIM LS!
il
R
DIGITAL -dB 60 50 403025 2015129 64 20-
If the unit began with the function ‘RENUMBER;, the
display shows for instance:
TRACK SIDE TOTAL TIME
{ PTricd
ht
L
DIGITAL
R
-dB 60 50 40 30 25 2015 129 6 4 2 0