Philips DCC 300 - Remote Control Functions; Remote Button Mapping; Special Remote Keys; Remote Control Battery Installation

The
keys
on
the
remote
contral
have
the
same
functions
as
the
corresponding ones on the ‘DCC 300’.
Exception: SEARCH = WIND and REWIND
Extra keys
0-9
digit
keys
To
select
directely
tracknumbers
(only
functional
when
using
a
DCC’).
STANDBY
To
select
the
‘STANDBY’
mode.
Batteries
e
Open
the
battery
compartment
and
insert
two
batteries
as
indicated,
type
RO3,
UM-4
or
AAA-ceils.
e
Remove
the
batteries
when
they
have
run
down
or
when
they
will
not
be
used
again
for
a
long
period.
Maintenance
® Pull the mains plug out.
e Clean the ‘DCC 300’ with a damp cloth.
e
Clean
reflecting
surfaces
(e.g.
the
display
panel
or
the
head
of
the
remote
control)
with
a
gentle
window
cleanser.
Cleaning cassettes
e In principle there is no need to clean the head of your
DCC player if you use only DCC cassettes. |
The use of conventional compact cassettes of inferior —
quality may leave dirt on the DCC head. This can aftect
the sound quality of DCC cassettes.
e Special DCC cleaning cassettes are available to clean
the DCC head.
e tis strongly advised not to use conventional compact
cleaning cassettes as they will not clean the DCC head
well enough.
Only use special ‘DCC cleaning cassettes’
for your ‘DCC 300"!
Do not use demagnetizing cassettes!
Probiems wiih the whole system
lf a fault occurs, read the points below before taking your
‘DCC 300’ for repair.
Electrostatic charge may cause unexpected symptoms, e.g.
the unit does not respond to any command.
To reset the unit:
e Switch off the power by pressing the
POWER ON/OFF key.
e Switch on the power again after a few seconds.
WARNING
Ifthese remedies fail to help, consult your dealer.
Under no circumstances should you try to repair the
unit yourself as that would invalidate the guarantee.
17