Philips DCM129 - Listen to Radio; Tune to a Radio Station; Program Radio Stations Automatically; Program Radio Stations Manually

11EN
5 Listen to radio
Tune to a radio station
Tip
•
Position the antenna as far as possible from TV, VCR or
other radiation source.
• For optimal reception, fully extend and adjust the
position of the antenna.
1 Press SOURCE repeatedly to select FM
source.
2 Press and hold / for three seconds.
» The radio tunes to a station with
strong reception automatically.
3 Repeat step 2 to tune to more stations.
To tune to a weak station:
Press
/ repeatedlyuntilyoundoptimal
reception.
Program radio stations
automatically
Note
•
You can program a maximum of 20 preset FM radio
stations.
In FM mode, press and hold PROG for three
seconds.
» The device stores all available FM
radiostationsandbroadcaststherst
available station automatically.
Program radio stations
manually
Note
•
You can program a maximum of 20 preset radio
stations.
1 Tune to a radio station.
2 Press PROG to activate program mode.
» The preset number is displayed.
3 Press PRESET +/- to select a number, and
then press PROGtoconrm.
» Thepresetnumberandthefrequency
of the preset station are displayed.
4 Repeat steps 2-3 to program more
stations.
Tip
•
To overwrite a programmed station, store another
station in its place.
Select a preset radio station
In FM mode, press PRESET +/- to select a
preset number.