11
English
Connect FM aerial
Tip
For optimal reception, fully extend and adjust the
position of the antenna.
For better FM stereo reception, connect an outdoor
FM antenna to the FM AERIAL socket.
The unit does not support MW radio reception.
1 Connect the supplied FM antenna to the
FM AERIAL socket on the main unit.
Set clock
1 In standby mode, press PROG/CLOCK
SET for 3 seconds to activate clock setting
mode.
» [CLOCK SET] scrolls on the display,
then the time format [24H] and [12H]
appears.
2 Press / to select 24H or 12H, then
press PROG/CLOCK SET
» The hour digits begin to blink.
3 Press / to set hour, then press
PROG/CLOCK SET again.
» The minute digits begin to blink.
4 Press / to set minute.
5 Press PROG/CLOCK SET
clock setting.
FM
Note
If you are not going to use the remote control for a
long time, remove the batteries.
Do not use old and new or different types of batteries
in combination.
Batteries contain chemical substances, so they should
be disposed of properly.
Demonstrate the unit’s
features
1 In the standby mode, press until
“DEMO ON” is displayed.
» This system’s features are displayed
one by one.
To turn off the demonstration, press
again.
a
b
c
EN
To Next Page
Loading...
Need help?
General
