10
Connect power
Caution
Risk of product damage! Ensure that the power supply
voltage corresponds to the voltage printed on the back
or the underside of the unit.
Risk of electric shock! When you unplug the AC power
cord, always pull the plug from the socket. Never pull
the cord.
Before you connect the AC power cord, ensure that
you have completed all other connections.
1 Connect the power cable to the wall
socket.
Prepare the remote control
Caution
Risk of explosion! Keep batteries away from heat,
To insert the remote control battery:
1 Open the battery compartment.
2 Insert 2 AAA batteries with correct
3 Close the battery compartment.
3 Get started
Caution
Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
bottom of the apparatus. Write the numbers
here:
Model No. __________________________
Serial No. ___________________________
Connect speakers
Note
For optimal sound, use the supplied speakers only.
Connect only speakers with impedance that is the
same or higher than the supplied speakers. Refer to the
1 Insert the speaker wires completely into
the speaker input sockets on the back of
the unit.
EN
To Next Page
Loading...
Need help?
General
