Philips DVDR3380 - Firmware Upgrading; Important Instructions

EN 6
3139 785 31810
3.
Firmware Upgrading
3. Firmware Upgrading
3.1 Firmware Upgrading
Important Instructions
• The Drive Upgrade and Loader Upgrade procedures has to be recorded into 2 separate disc.
A. Preparation to upgrade firmware:
1. Unzip the zip-archive file
2. Copy the files into different folder for burning into separate CD-R/CDRW.
3. Start the CD Burning software and create a new CD project (data disc) with the following settings:
File system : Joliet
Format : MODE 2: CDROM XA
Recording mode : SINGLE SESSION (TRACK-AT-ONCE), FINALIZED CD
Note: Long file name is necessary for the preparation of the upgrade disc
4. Place the file into the root directory of the new CD project.
5. Burn the data onto CDRs or CD-RWs
B. Procedure to apply the Drive upgrade:
1. Open the tray and load the Upgrade CDROM with Drive Upgrade file.
2. The tray closes and set will display:
“DRV UPG”
3. The OSD will display
“Loader Software Upgrade Disc detected.Select OK to start upgrading or CANCEL to exit.”
4. Click on the OK button.
5. The set will display:
“DRIVE UPGRADING”
With the OSD display
“Upgrading Software. Please Wait. Do not switch off the power.”
The whole process takes less than 5 minutes
Note: Do not press any buttons or interrupt the mains supply during the upgrading process, otherwise the set may becomes
defective.
6. When the upgrade is completed the tray will open automatically and the set will display:
“Loader Upgrade process has completed successfully .Press <OK> to reboot system.”
7. The tray open and the set will display:
“DRV OK”
8. Press <OK> and the set goes to standby .