Figure 7 – Dismantling of PSU Board
2) Service position for PSU Board is given in Figure 8.
Figure 8 - PSU Board Service Position
Insulation Sheet
1.5. Dismantling of the Mono Board and the Tuner Board
1) Remove 6 screws from the Rear Plate and remove 2 more screws from the Frame 161 to dismantle the
Mono Board 1003 (and the Tuner Board 1005) as shown in figure 9 and figure 10.
Figure 9 – Remove the screws from the Rear Plate
Figure 10 – Remove the screws from the Frame
2) Service Position for Mono Board is shown in figure 11.
To Next Page
Loading...
