Philips DVDR7310H - Step 3: Installation and Set-Up

English
25
Step 3: Installation and Set-up (continued)
E
The Channel Search menu appears on
then TV. Select { Channel Search } in
the menu and press OK on the remote
control to start.
 It takes a few minutes to complete.
CHANNEL SEARCH
Automatic Channel search will find and store all channels.
Make sure to connect the antenna!
Channel Search
Skip Search
Start
OK
Note: Make sure you have successfully
made all the required connections to this
recorder, the TV and Satellite Receiver/
Cable Box (if any) and turned them on.
The channel search will detect the signals
and save all the available programme
channels.
If no channels are found :
– Try the auto TV channel installation
after completing the basic installation, see
page 78.
F After the channel search is  nished, the
total number of found and stored
channels appears, press OK to continue.
CHANNEL SEARCH
Restart Search
Continue
OK
Analogue TV channels found: 9
G The time and date menu appears.
TIME AND DATE
Please check the Time (hh:mm) and Date and correct
if necessary.
Time
Date
Done
20:01
31-01-2006
OK
Disc tray will not open until setup is completed
i. If the information is correct, select
{ Done } in the menu and press OK.
ii. If changes are required, use the
alphanumeric keypad 0-9 to enter
the correct time and date in the
respective  eld.
H The basic installation is now completed.
Easy setup completed. Continue with the GUIDE Plus+
installation?
Continue
Donot install now
OK
OK
Disc tray will not open until setup is completed
i. Select { Continue } in the menu and
press OK to start the GUIDE Plus+
installation. See next page for the
complete detailed setup.
ii. Select { Do not install now } in the
menu to skip the GUIDE Plus+
installation. The next time when you
want to install the GUIDE Plus+
system, press GUIDE on the remote
control, see next page.
I Wait until the recorder has  nished
initialising the system, then press OK to
exit.
You may now enjoy using this
recorder.
Helpful Hint:
– The TV programme listings do not appear
on the GUIDE Plus+ system as soon as you
complete the basic installation. It may take
up to 24 hours to receive TV listings data.
TIPS: After completing the basic installation, you can change or update your settings using the system
setup menu, see page 75~81.