Philips DVDR7310H - Page 89

English
Problem (Recording) Solution
Troubleshooting (continued)
Recordings are not occurring
as scheduled. New
recordings cannot be made.
The wrong TV channel was
decoded (recorded) after
you programmed a
recording using the
ShowView / VIDEO Plus+
system.
The index screen  ickers
when a DVD±R is inserted.
Picture is fuzzy and
brightness varies when
played back your recording.
The DVD+RW/-RW cannot
be used for recording on this
recorder. Even though it has
been formatted using the PC
drive.
– The TV channel you want to record is not stored or you
selected the wrong programme number. Check the TV channels
stored.
– You must reset the timer recording after adjusting the clock
setting.
– You cannot use the recorder to duplicate copyright material
(DVDs or videotapes) onto a recordable DVD, “COPY PROT”
will be displayed.
– ‘VPS/PDC’ is turned on but ‘VPS/PDC time’ is wrong. Enter the
exact ‘VPS/PDC time’.
1) Enter the ShowView / VIDEO Plus+ PlusCode programming
number of the desired TV channel.
2) Press OK to con rm.
3) Check the channel number in the {Ch.} input  eld. If this does
not correspond to the desired TV channel, select this entry
 eld and change the channel number.
4) Press OK to con rm.
– You can  nalise the disc using the following function:
1) Press OPEN CLOSE on this recorder to open the disc tray.
2) Insert the disc but do not close the tray.
3) Hold down button number {4} on the remote control until
the tray closes. ‘FINALISING’ appears on the display panel.
4) If  nalising has been successful, the Picture Index screen will
appear.
– This happens if you try to copy DVDs or video tapes that have
been copy-protected. Even though the picture on the TV is  ne,
the recording on the recordable DVD is faulty. This
interference is unavoidable with copy-protected DVDs or video
tapes.
– The recordable DVD has a limited recording lifetime, use a new
disc for recording.
– You have to re-format the DVD+RW/-RW.
1) Press OPEN CLOSE on this recorder to open the disc tray.
2) Insert the disc but do not close the tray.
3) Hold down button number {0} on the remote control until
the disc tray closes.
4) Start recording on the DVD+RW/-RW before you remove it
from the disc tray.
89