91
7 If all information is correct, press the OK button. The data is stored.
8 To end, press TIMER s .
9 Insert a recordable disc (one without write protection).
The inserted disk is checked.
0 Search the position on the disc where the recording should begin.
A Switch off the DVD recorder using STANDBY m .
The programmed recording functions only if the DVD recorder has
been switched off using STANDBY m .
If one or more recordings have been programmed 'TIMER' will light up on the display.
Programming recordings without the
VIDEO Plus+
®
System
1 Switch on the TV set. If required, select the programme number for
the DVD recorder.
2 Press TIMER s on the remote control.
The 'Schedule' screen appears
VIDEO Plus+ Manual Home
Schedule displays programmes for Watch or Record.
Press Bto use. Press the Red button for VIDEO Plus+
recording. Press the Green button for Manual
recording. Press Dfor Search. Press Cfor Info.
Grid Search Schedule Info
No programmes
3 Press the green button.
The current date will be displayed.
4 Enter the date using the number buttons 0..9
5 Confirm with OK .
How can I correct wrong entries?
If you have already confirmed the entry with OK , you can select one of the
following functions:
Repeat entry: Green colour button
Cancel: Red colour button
?
6 Enter the start time for the show using the number buttons 0..9 .
Confirm with OK .
7 Enter the finish time for the TV show using the number buttons
0..9 Confirm with OK .
ENGLISH
Programming a recording (TIMER)
To Next Page
Loading...
