EarlyVue VS30 Instructions for Use 17-1
17
Troubleshooting
Use the information in this chapter to diagnose and correct problems with your monitor
and its accessories. If you cannot resolve a problem after using the information in this
chapter, contact your system administrator or biomedical engineer.
Maintenance and repair beyond the troubleshooting described in this chapter must be
performed only by trained service personnel. Contact your system administrator or
Philips Customer Care Center if the VS30 monitor or accessories are not operating
properly after troubleshooting.
Viewing System Information
Important monitor information, such as the hardware ID and the software version, is
displayed on the Device Info tab in the System menu. For more information, see
“Networked Monitors” on page 2-26.
Diagnosing a Problem
Before you begin to troubleshoot a problem, check the following basics:
1. Is the power turned on?
2. Is the battery adequately charged?
3. Is the power cord connected to the monitor and plugged into an AC power source?
4. Is the display functioning?
5. Are the LEDs on the right side of the monitor lit as you expect?
Note
It may take several seconds for the AC Power LED to light or turn off after the power cord
is connected or disconnected.
When the monitor has power and a functioning display, use the information in this
chapter to diagnose other monitor problems.
To Next Page
Loading...