PHI 5000 01 INTRODUCTION
11/9
Reset to the default settings
Alarm signals summary: red display
Warnings signals summary
It is possible to restore the default settings through the programming
menu. The machine must be turned on and ready to work.
Press the MENU button and scroll through functions list to select the
RESET function.
Press the OK button to select the function.
When the change has been implemented, the OK message will be
displayed.
Press the ESC button to exit the programming function.
The machine automatically exits the programming mode if no button is
pressed for 3 minutes.
>
>
RESET
>
Display Description
Put back the drip tray
and coee grounds
drawer; close the
service door.
Coee bean
hopper empty.
Brew group not
inserted.
Display Description
Coee grounds
drawer full.
Water tank empty.
The machine is out of
service.
XX
Display Description
The machine is ready to
brew products: coee
bean hopper empty
If the lter signal starts
blinking, the AquaClean
lter must be replaced.
The machine is waiting
to start the water circuit
priming process.
The milk carafe ducts
should be cleaned.
Display Description
The machine must be
descaled.
The machine is heating
up.
The machine is rinsing.
Brew group rebooting.
FILTER
START
CALC
CLEAN
START
CALC
CLEAN
START
CALC
CLEAN
FILTER
Only OTC
START
QUICK
CLEAN
To Next Page
Loading...