EPIQ 5 & 7 Training Manual
© 2016 Conquest Imaging
Backplane
The main function of the backplane is to distribute power signals to
other parts of the system minimizing the numbers of cables attached
directly to other modules.
The backplane itself contains no active circuitry or components
although it does have a power switch (PWR_SW) and a reset switch
(RESET_SW) that connect to the power pins on the motherboard.
Reset starts a reboot of the system.
The backplane is part of the E-module and is located above the
motherboard. On the dual processor model the backplane
underneath the E-module is difficult to see, you have to move cables
to see it.
Backplane Switches
To Next Page
Loading...