9
English
Problem Possible cause Solution
The suction opening in
the bottom of the nozzle
is blocked with dirt and
this prevents the sensor
that activates the lights
to work.
Clean the suction hole in the bottom of the
nozzle by removing the threads and hairs that are
blocking the air passage. Scrape the air passage
clean with a plastic or wooden tool. To clean the
sensor hole, use a cotton swab and turn it a little
to remove the dirt.
The LED lights of the
nozzle flash or do not
give out a steady
beam of light while
vacuuming.
The batteries are running
low.
Replace empty disposable batteries with new
ones. If you use rechargeable 1.5V batteries,
recharge them in a separate battery charger.
The nozzle does not
vacuum up dirt.
The air passage in the
nozzle is blocked with
threads and hairs.
Clean the air passage of the nozzle by removing
the threads and hairs from the suction opening in
the bottom.
To Next Page
Loading...
