Philips Fidelio B1 - 6 Product Specifications

14 EN
5 On the remote control, within 6 seconds
press
twice then Volume + once, and
then hold down MOVIE.
» Then "UPG" (upgrade) is displayed on
the display panel.
» If a USB ash drive is not connected or
invalid upgrade le is found, "ERROR"
(error) is displayed on the display
panel.
6 When “UPG” blinks, press on the
remote control to start the upgrade.
7 Wait until the upgrade is completed.
» If the upgrade is complete, this product
automatically turns off and on again.
Note
•
The upgrade time may take around 3 minutes.
6 Product
specifications
Note
•
Specications and design are subject to change without
notice.
Amplier
• Total output power:
320W RMS (+/- 0.5 dB, 10% THD)
• Frequency response: 20 Hz-20 kHz / ±3 dB
• Signal-to-noise ratio: > 65 dB (CCIR) /
(A-weighted)
• Input sensitivity:
• AUX: 1900 mV
• AUDIO IN: 900 mV
Audio
• S/PDIF Digital audio input:
• Optical: TOSLINK
USB
• Compatibility: Hi-Speed USB (2.0)
• Class support: USB Mass Storage Class (MSC)
• File system: FAT16, FAT32, NTFS
• Playable audio les: .aac, .mp3, .m4a,
Bluetooth
• Bluetooth proles: A2DP, AVRCP
• Bluetooth version: 4.1
Main unit
• Power supply:
• Model (Philips branded AC power
adapter): DYS602-210309W;
AS650-210-AA309
• Input: 100-240 V~, 50/60 Hz 1.5 A
• Output: 21V
, 3.09A
• Standby without clock display: ≤ 0.5 W